The Dentist Magazine.

Virtual models and 3D printing improve jawbone regeneration

Published: 9/7/2018 12:00:00 AM

A recent case letter in the current issue of the Journal of Oral Implantology shows that digital techniques can help create and position titanium mesh to help with bone regeneration.

Dental implant technology has advanced greatly over the past few decades, allowing for more cost-effective procedures. Often, when a patient loses teeth due to trauma or disease, bone loss ensues that makes it difficult or impossible to use dentures or dental implants. To combat this problem, bone grafting, a surgical procedure that replaces bone, is often used to serve as a support for dental implants and replacement teeth. Often titanium mesh is used as a tent over the bone graft to support the graft’s shape and volume while the new bone grows. However, titanium mesh can be logistically challenging and time-consuming to form and position in the patient, and it can irritate the soft tissues in the mouth. A recent case letter in the current issue of the Journal of Oral Implantology describes a technique to create and position titanium mesh to improve guided bone regeneration.

In collaboration doctors from Loma Linda University, King Khalid University, and King Saud University encountered a patient who had several missing front teeth due to an injury that resulted in a large gap referred to as a bony defect. The authors decided to begin with a bone graft, followed by dental implants that would support the replacement teeth. They created a virtual 3D model of the patient’s mouth and bony defect, then, with a computer program, determined the correct position and placement of the bone graft based on the desired location of replacement teeth. They 3D printed a model and fabricated the titanium mesh to fit the intended bone position and volume. The authors filled the titanium mesh with bone harvested from a remote location in the patient’s mouth and secured it in the site of the missing teeth with fixation screws.

By digitally creating the titanium mesh, the authors were able to ensure that the material was the precise shape and volume needed for the patient’s bone defect. This reduced the chance that the titanium mesh would cause an unfavourable outcome during healing, including mesh exposure and irritation. During surgery, the authors ensured the proper placement of the titanium mesh and bone graft with a positioning jig fabricated from a clear plastic mould that used the existing teeth to hold the mesh in place while it was being secured. Finally, to improve wound healing and bone stability, they applied fibrin membranes rich in platelets.

“Virtual 3D planning has become more popular in recent years when planning for implant placement,” said author, Aladdin J. Al-Ardah. “Our technique ensures precise augmentation of the bony defect and an accurate positioning of the mesh.” The authors concluded that prefabrication of titanium mesh also reduces surgical time and ensures that the location of replacement teeth will be correct. Future work is needed to improve fabrication of the positioning jig as well as to determine the dental procedures for which this technique would be appropriate.

The full text of the article ‘Using Virtual Ridge Augmentation and 3-Dimensional Printing to Fabricate a Titanium Mesh Positioning Device: A Novel Technique Letter’, has been published in the Journal of Oral Implantology,  and is available at http://www.joionline.org/doi/10.1563/aaid-joi-D-17-00160